![]() |
#191
|
|||
|
|||
![]()
Unfortunately nothing is done on this issue. However, a lot of good things (more realistic cut out behaviour of early Merlins removed) are tuned down ...
|
#192
|
||||
|
||||
![]() Quote:
I do know that if you push the float up in a float carburetor, the flow of fuel stops. While my airframe is aerobatic, my engine has a float carburetor. The mere suggestion of negative G's will cause the engine to spool down. There is no way a float carburetor can perform a negative G loop. ![]() |
#193
|
|||
|
|||
![]() Quote:
This is a single page of a two page document that is dated in the usual pattern in the signature block on the last page, the document date is 21/12/1940. The remaining documents in the file are dated 20/12/1940 and 21st February 1941. What is the relevance of the 109 Auto Prop pitch statement ?? Last edited by IvanK; 08-11-2011 at 06:27 AM. |
#194
|
||||
|
||||
![]() Quote:
I was able to make a negative loop with the RAF types in the case that the CEM is turned off only... Nothing.
__________________
![]() ![]() i7 7700K 4.8GHz, 32GB Ram 3GHz, MSI GTX 1070 8GB, 27' 1920x1080, W10/64, TrackIR 4Pro, G940 Cliffs of Dover Bugtracker site: share and vote issues here |
#195
|
|||
|
|||
![]()
The cut out was a 2 stage event. The 1st stage caused a momentary loss of power > a lean cut out. The 2cd stage of the cut out was the more serious cut out as the float floated the wrong way and openedthe inlet fully allowing full fuel pressure to the carb and thus flooding the engine > rich cut out.
|
#196
|
|||
|
|||
![]()
i usually fly with the E1
Much better for me than the E3 [to much shaking when you fired the cannons ![]() plus that i have more records with the E1.. ![]() |
#197
|
|||
|
|||
![]()
Really i can´t see any difference (in performance) between the Ia and the IIa, except for the Rotol constant pitch control, except of that, both of them has +6 lb, same speed, same climb rate, same maneuverability, same guns ... why most servers don´t allow to play with them?
|
#198
|
|||
|
|||
![]() Quote:
Really?!? ![]() |
#199
|
|||
|
|||
![]() Quote:
|
#200
|
||||
|
||||
![]() Quote:
That is the whole purpose of leaning the mixture to maintain that ratio as the density altitude gets higher. |
![]() |
|
|