4.11 General debugging

[Pfeil]

Originally Posted by Bionde

The gauge indicates different values from the devicelink.

Which devicelink key are you checking? 68(temp_oilin) appears in sync with the cockpit gauge, 70(temp_oilout) does not. This seems correct to me.

[Bionde]

Yes, is the oil in, I used the devicelink with UdpSpeed and another application for android which I found here and the value from game to the devicelink is different.

[idefix44]

Attachement: CielDeGuerreBug.mis

Using IL2 1946 4.11.1m without any mod.

Opening the file with the FMB, I'm unable to see the [0_Chief_Road] and [1_Chief_Road] on the map.

Where are my columns ?

[KG26_Alpha]

Originally Posted by idefix44

Attachement: CielDeGuerreBug.mis

Using IL2 1946 4.11.1m without any mod.

Opening the file with the FMB, I'm unable to see the [0_Chief_Road] and [1_Chief_Road] on the map.

Where are my columns ?

Make sure you have all the filter boxes checked in the FMB


I see no Russian supply columns only moving armour and artillery.

Axis supply

German supply column Type II
B-2
to
C-3

Fuel supply column
D-7
to
E-6

[302_Corsair]

Is there a posibility that bomb set to low-level 4 s. delay will explode immediately after hit the ground? Is there some kind of failure for the bomb fuze? My approach was about 1000m alt, 30 deg. flat dive. I droped the bomb 180m over the ground and my speed was 580km/h. Aircraft - P-40M with 1000lbs bomb.

[idefix44]

A lot of .mis files are impossible to laod with the 4.11.1m FMB.

Is't a know bug?

[Viikate]

Originally Posted by idefix44

A lot of .mis files are impossible to laod with the 4.11.1m FMB.

Is't a know bug?

It is a corrupted mission. Possibly edited outside FMB? Change "gust 4" to "gust 0" and it will load.

[Tolwyn]

Track:
http://files.tolwyn.com/engine_weirdness2.ntrk

This makes using engine 1/2/3/4 select an impossible issue.

Introduced in 4.11:
DISABLE manual view so you can watch what I'm showing.

Deselect both engines
Show that both are deselected
Select engine 1
Start engine 1
Deslect engine 1
Select engine 2
Start engine 2
Select both engines, bring throttle to idle

This is "normal starting position"

DESELECT engine 1 (conversely, enable only engine 2)
Bring engine 2 to idle
Feather engine 2
Shutdown engine 2
DESELECT engine 2 (we don't need it anymore)
SELECT engine 1
Show that engine 1 is selected (throttle up, then throttle down, etc.)
Bring engine 1 to 70% power; note that all is fine.
SIMPLY DESELECT engine 1 (essentially NO engines are selected at this point)
Watch the RPMs climb in engine 1
Repeat tests. You can easily get engine 1 to fail by simply deselecting it and not changing any other parameters.