Throttle Quadrant levers are recognized only 30%

[Royraiden]

After mapping my axes for trim, throttle, mixture and radiator I noticed that only 30% of the levers are recognized.What do I need to do for the sim to recognize the full movement of the axes?

[Strike]

Make sure you set the small sliders in the "axis" window from 0% to 100%.. I had this issue too. If the minimum is set to 0. and the maximum to 5% travel. Then you throttle will go from 0 - 100% ingame when you slide your hotas beyond 5%.

try that :)

Lookie

[Royraiden]

Thanks a lot, I will try that.

[O_TaipaN]

Hi,

Once you have it going how do you like the CH Quadrant?

Would you recommend it over the Saitek?

Cheers