4.13.2 de-bugging

[ElAurens]

I have encountered this on other aircraft types in the past.

First, try resetting the rudder trim before you take off. Use whatever keys you have bound to set your rudder trim to zero, or just adjust your rudder trim to "center the ball" once in flight.

If you are not using rudder trim at all, well, you NEED to.

[nic727]

Hi,

Just a quick question about an Issue I have since I reinstalled the game on my new laptop.

Each time I start the game, a lot of stuffs are reset for no reasons. What I mean is that each time I start the game and fly, I have to re-add the mirror in the plane and click F9 to have a movable camera. I remember that on my old laptop, mirror was here every time and camera was ok. Anyway to fixe this? Maybe it's problem with my laptop?

[stovak]

Nic, maybe the settings files were copied as 'read only'? Check the properties of your conf.ini and settings.ini and make sure the 'read only' box is not checked.

There may be other files in the user folder as well, I'm not sure where all the setting are stored.

[nic727]

Originally Posted by stovak

Nic, maybe the settings files were copied as 'read only'? Check the properties of your conf.ini and settings.ini and make sure the 'read only' box is not checked.

There may be other files in the user folder as well, I'm not sure where all the setting are stored.

I don't have Read-only checked, so that's not the problem.

[Tolwyn]

Can we bring back the Lerche's chocking functionality?

Since chocks do not work with the Lerche anymore, if you utilize any of theTest Runways (Stationary Ships) and target the takeoff waypoint to the Test Runway, you cannot take off because you cannot UN-chock.

Your lerche is stuck.

[stovak]

Originally Posted by nic727

I don't have Read-only checked, so that's not the problem.

Ok, it's strange though because the mirror setting is stored in the conf.ini. I've tried this a few times and (in my game) the setting is not saved with read-only checked, but it is saved when read-only is unchecked.

Can you manually alter the conf.ini? If you have the following setting, you should start with the detailed mirror view.

[game]
viewSet=8

(viewSet=4 is simple mirror, viewSet=2 is no mirror)

viewSet may have different numbers, but you can ignore those.

[nic727]

My viewset is 53. Is it normal?

Also what about my pano/instant view with F9?

[stovak]

Yes, that's normal. viewSet is affected by several settings, including the F9 Pan/Snap view so the number can be different depending on your settings. I don't understand it completely, but I've tried it with different numbers to test the results. With viewSet=53 you should already be starting with Pan View and a mirror.

The main point is that if you change these settings in game then the number will change and it should be saved to the conf.ini when you exit the game.

If that is not working, try editing the conf.ini manually as I said before, to see if it has any effect. If it doesn't change anything, then maybe il2 is not even reading the conf.ini