Realism, whats missing?

[K_Freddie]

Sorry.. meant with a bit of elevator input + full yaw.

Using a P51 in IL2 and DCS.. I tried to snap roll it using full elevator and rudder with no aerolons. Engine was on idle to minimize torque and propwash.

1) The IL2 replied with immediate wing stall and roll
2) The DCS P51 made an attempt to yaw and nose up.. and refused to do anything. It hung there wobbling, as if in a software loop that was going nowhere. They went off their rockers when I pointed this out....

Having found that great instructional video that I've posted, I set up both aircraft turning with full yaw and slight cross controls, so as to keep it just on the stall zone. I then applied full aerolon which should have induced a stall.

DCS again did nothing and rolled in the direction of application, still refusing to stall when I applied complete cross controls.
IL2 also did not respond fully but did wobble a bit... and was much slower to roll over - but effectively showed that this FM wasn't modeled that much.