Having problems trimming planes (mainly nose trim)

[Woke Up Dead]

You probably know this already, but most bombers have a key for perfectly level flight for high altitude bombing.

[MaxGunz]

Trim the stab as much as you can just on the high side then nudge the power a bit down.

Are you keeping an eye on slip?

[Raven Morpheus]

Originally Posted by MaxGunz

Trim the stab as much as you can just on the high side then nudge the power a bit down.

Are you keeping an eye on slip?

Stupid question but what's slip?

Also, as I'm not up to speed on the terminology used in this sim (or real world flying) can I take it you mean trim the nose so it's slightly climbing and then back off the power?


I tried the keyboard the other day, I admit I forgot I could use the keyboard, and it did provide slightly better adjustment.

It would be nice to get the plane so I don't keep porpoising because I'm constantly trimming it up or down, especially seeing as the AI always seem to be able to fly straight and level, so I'd like to know if there is anyway to get accurate trim on a fighter without having to buy a bespoke trim control or DIY it.


@Woke up dead - do you mean the Level Autopilot function? I rarely use bombers anyway so that's not much use to me, unless it works in fighters, but I don't want autopilot having control of a plane that wouldn't have had autopilot in the first place.

I guess I'm just stuck porpoising all over the place.

[fruitbat]

I have always found that trimming planes at high power settings is much harder than at cruise settings. in my experience, most planes will trim out pretty nice at lower power settings (pitch and power)....

[MaxGunz]

Slip is when your plane is not pointing where it's going side-to-side. It's what the smiley curve with the ball in it tells you you have, though in a Spit it's a needle down on the lower right of the instrument panel.

Slip makes drag, it slows you down. If you're in slip when you stall, you spin. Slip will throw your shots off to one side.

You fix slip with rudder, hence the term "step on the ball".

[fruitbat]

Originally Posted by MaxGunz

You fix slip with rudder, hence the term "step on the ball".

and rudder trim on planes that have it

[Raven Morpheus]

Originally Posted by fruitbat

I have always found that trimming planes at high power settings is much harder than at cruise settings. in my experience, most planes will trim out pretty nice at lower power settings (pitch and power)....

This is obviously something else I need to learn. Did I say I'm not particularly good at the game.

Whatever plane I fly (currently I'm in careers with the Hurricane in Singapore/Battle of Britain mod and the F4 Corsair in the Pacific) I stick the pitch at 100% and power at 100%, and I can only just about keep up with my AI flight team.

Oddly I've done OK up until now, I wasn't too bothered about trim, but it's becoming a pain in the proverbial (arm and wrist mostly) to keep the plane on a sort of level flight and keep on correcting it with the joystick, I'm just looking for an easier time of it when not in combat.

Are there any recommended pitch/power settings for each plane?

Originally Posted by MaxGunz

Slip is when your plane is not pointing where it's going side-to-side. It's what the smiley curve with the ball in it tells you you have, though in a Spit it's a needle down on the lower right of the instrument panel.

Slip makes drag, it slows you down. If you're in slip when you stall, you spin. Slip will throw your shots off to one side.

You fix slip with rudder, hence the term "step on the ball".

Hmm I think I get what you mean, you're going forward but also sideways. But once I'm off the ground and en-route to target I don't generally use a lot of rudder, if any. Any idea where that particular dial is on the Corsair/Hurricane?

[fruitbat]

Hurricane, its the bottom right dial on the main panel, and its the needle that points vertical. Vertical is no slip, left and right= slip.

Corsair, its in the centre bottom of the main panel, and its a ball in a tube which is curved like a smile, ball in centre = no slip.

With a well trimmed plane, you will fly a faster, and actually don't need as high power settings, as if you are not trimmed.

you can also use your climb indicators to check you are trimmed out level as well.

You can actually practise flying a plane with just trim, if you go in the qmb, with no enemy, its possible to turn and climb and descend just with elevator and rudder trim, without even having to use your stick.