Game crashing: OpenGL message “lost connection”

[KG26_Alpha]

Hi

Did the last DX entries get cut off when copy/pasting or are they missing in the conf.ini ?

If they are in the conf.ini or you have a back up proceed with the following:

A. Make sure the conf.ini resolution is the same as the monitors resolution, so if the monitors running a resolution of 1920x1080 as in your conf.ini
[window]
width=1920
height=1080
This is correct.

B. Make sure you clean the old driver registry entries and old driver files from your system before installing new drivers.

You can use a driver cleaner utility like this one.

http://www.guru3d.com/files_get/guru...taller),7.html

Run it in safe mode.

http://www.bleepingcomputer.com/tuto...-in-safe-mode/

Clean all video/gpu related drivers and if you had an ATI card in there before run it to clean those entries as well.

Once its clean boot up normally and install the recommended driver and settings.

Only after doing this should you pursue any of the other fixes related to Timeout Detection and Recovery (TDR)