![]() |
|
|
|
#1
|
||||
|
||||
|
Don't you mean I'll be bock!
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5 |
|
#2
|
|||
|
|||
|
Is that you Furbs? Something fishy going on here..
Moderators please check IP Ps .. I had another blown engine on the 109 this time an E1..temps were Ok and boom, I cold see flak bursts so it may of been that but no visible DMG on wings or did I get any DMG/flak hit sounds.. 2 flights since last RC patch and both blown engines after getting alt for 20mins. Gotta love it. Glad your enjoying it Furbs, see you in zee air |
|
#3
|
||||
|
||||
|
Cheers!
I didn't see one moment of lagging or warping aircraft last night A few things that would made it even better would be a fix for the LOD issue, some good FSAA and maybe some change to the skins online, apart from that it was a real improvement. I also didn't get the loss in FPS when zoomed in, which was a big plus. Bliss have you looked into allowing skins online now? Maybe a test night?
__________________
Furbs, Tree and Falstaff...The COD killers...
|
|
#4
|
|||
|
|||
|
Yes Furbs you shot me down low over Dunkirk in a Hurricane, I hate the new patch lol!!!. In all honesty it`s a great step forward bodes well for BoM/S/?
|
|
#5
|
|||
|
|||
|
Ahh I do believe you, Gruber and I gang banged a Hurri or two between Calais and Dunkirk.
Glad your finally enjoying it! S! |
|
#6
|
|||
|
|||
|
Same here, flew over Calais, climbing, and then engine failure....no WEP or too high RPM, coolers open...
|
|
#7
|
|||
|
|||
|
Quote:
Even in Singleplayer mission testing. |
|
#8
|
|||
|
|||
|
You can't fly around at 1.35 ata all day anymore. Save 1.35 for combat and cruise at 1.3 or lower.
|
|
#9
|
||||
|
||||
|
I think I read 1.1 is optimum for cruise
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5 |
|
#10
|
|||
|
|||
|
Goto 14 seconds on this vid, pause it, set to hi def and full screen... You will see the engine settings and durations.
|
![]() |
|
|