Bug-Thread for RC1&2 British Engine Hotfix + SLI/Crossfire test & RC2 release

[*Buzzsaw*]

Salute

All the WWII Fighters should be capable of Stall turns, hammerhead turns etc.

Rudder effectiveness should be more than sufficient at low speeds.

[Kwiatek]

Still Merlin engines stops at idle - not fixed

Still British planes are too slow at ab. 20-30 mph at the deck - 100 Octan fuel version at +12 lbs (emergency) reach only speed accurate for IRL 87 Octan fuel at +6 1/4 lbs. The same 109 is too slow ab. 20-30 kph. Not mention high alt perfomacne. I wonder why speed of British fighter some time ago was degrated where it was more accurate then now instead just rise 109 speed. Now Spitfire MK II can't reach even 280 mph at emeregency +12 boost 3000 RPMs - speed which should be reached only at + 9 lbs - nominal power.

Again rudder is less effectivness then should - it is not possible to make good stall turn in fighters becasue of weak rudder. PAtch before at least in 109 rudder was much better and was possible to make quite good stall turn. Su26 is better - it is possible to make good stall turns ( it is need to use only some degree of rudder).

[badfinger]

Sorry to have to ask, but I haven't added the RC patch, yet. Should I do that first, or go straight to the hot fix?

Binky9

[Jaws2002]

Originally Posted by binky9

Sorry to have to ask, but I haven't added the RC patch, yet. Should I do that first, or go straight to the hot fix?

Binky9

By nature, a hot fix is a small patch that goes on top, and fixes a bigger patch, it doesn't replce the former patch.

So instal RC first then drop the hot fix on top of it.

[Winger]

Sorry i posted this in the patch thread already. But i think here is the right place where it belongs:

My Summary:

SLI works and gives good performancegain with AFR2 enabled.

SLI Produces INSANE unbearable visual tearing.

Visual tearing appears WITH (AFR2) or WITHOUT (FORCE SINGLE) SLI being activated in a manual set up profile.
In order to avoid visual tearing i have to deactivate SLI in the driver itself.

The selected Vsync setting in driverprofile DOES affect Framerate. Thus i get over 100 frames and tearing with AFR2 on and Vsync OFF and 60 Frames with AFR2 on and VSync ON.

Another thing i noted is that clod no longer stretches the picture the the monitorsize. When running 2560x1600 native desktopresolution i get black borders on all sides of the picture when i run the game in 1920x1200 resolution fullscreen set to ON.
So i have to lower desktopresolution to match ingameresolution if i want to avoid playing on something that looks like a postage stamp.

Single GPU performance is OK.

Winger

PS: Oh and the driver i am using is the newest 306.63