Patch road map ?

[jf1981]

Originally Posted by IvanK

"I've also learned that it should'nt be the case [...] Unless you are really interested in best fuel consumption then Auto Rich is all you should really need.

I am indeed. When we do fly some historical battels, most of us are falling down due to lack of fuel or lack of lifting surfaces generally.

[FFCW_Urizen]

AFAIK jf, the Merlin can handle 6.25 lbs/3000rpm only for 30 mins, before issues occur. However, as it is now, you are lucky if you can go 2800rpms without cooking your engine and that is in level flight.

[FS~Phat]

Ive found if you apply a bit of common sense and watch your temperatures you can get by. Ive run with boostcut and water temp up to 120c and oil to 97c for about a couple minutes without failure but water needs to be mostly under 110c and oil 95c to avoid damage. With temps properly managed I have run boostcut continuously for 30mins without any noticeable damage.

[Redroach]

Though I am not really into in-depth-knowledge of engine limitations, I do agree that current performances are a bit shaky at best.
Before the current beta patch my guideline was "2600rpm with full boost (sans c/o) for continuous operation" (*) for both the SpitMkIa100oct and the Hurri100oct. But now, even that is no more guarantee... you really seem to be forced to tone it down to about 2400-2500rpm in order to maintain reasonable oil/cooling temperatures.

(*) The spit Mk I manual even says that somewhere, if I remember correctly - but the other limits, like the cut-out limit of 5 min. or the rpm limit of 3000 for i-dont-remember-how-long-exactly were always way off imo.

[Blackdog_kt]

Originally Posted by jf1981

Yes, to be considered.
If it's modelled right, mixtures pulled back is rich, then it shall be ok. And when pushing away, the engine's rough under many conditions.

I've also learned that it should'nt be the case since they are normally auto rich and auto lean so lean shall work better in theory.

Actually, even with semi automatic mixture it's advised to use auto-rich whenever using high power settings. That depends on the aircraft and doesn't only mean WEP/boost cut out. It could also mean any boost above +5.

I don't know what the real aircraft used and how it's modeled in the sim, but from flying various A2A add-ons on a friends's FSX installation and after reading various manuals of real aircraft, it's pretty clear that high power needs rich mixture.

I think it's because it helps cool the engine and prevents detonation. I think detonation is improper fuel burning through pre-ingition, which damages the piston rods because they are out of alignment at the time of ignition, but i'm not entirely sure.

Generally speaking and as a safety measure, only use auto-lean for cruise. Cruise means the specified engine settings, not simply flying straight and level at whatever boost we want, it could be as low as +1 boost. Take-off, climb and combat should be done on rich, as well as fast cruise.

I don't know the limits for the Merlin (Spits and Hurris) but just as an example, let me give you the Mercury engine limits from the Blenheim pilot's handbook. The engine can do +5 at full throttle and +9 with the boost cut-out activated.

Nevertheless, anything above +1.5 requires auto-rich:
economy cruise is +1.5 at auto-lean
fast cruise is +3.5 at auto-rich.

In other words, just because there is spare power it doesn't mean it's sustainable at all times and conditions. That being said, i agree that some of the in-game limits are currently off the mark.

[jf1981]

Originally Posted by Blackdog_kt

Actually, even with semi automatic mixture it's advised to use auto-rich whenever using high power settings. [...]
In other words, just because there is spare power it doesn't mean it's sustainable at all times and conditions. That being said, i agree that some of the in-game limits are currently off the mark.

Yes, all tests made in auto-rich. High power on auto-lean at one's own risks in principle, and soon or later damaging the engine in most cases.

[jf1981]

There is no plan we can get from BlackSix or dev team ?

It's ready when it's ready was not a so good answer.