v1.05.15950 PATCH BUG THREAD

[nakedsquirrel]

He111 - 3d model for elevator/aileron/rudder trim is backwards

German bombsight is set in miles, not km so you have to manually convert to hit your target.

[Heinz Laube]

Originally Posted by nakedsquirrel

German bombsight is set in miles, not km so you have to manually convert to hit your target.

coverting to miles is just a workaround, they "only" forget to give us the possibility to set the "Rücktriftwinkel" ( Drift-angle) on the Lotfe 7... its a important Input, since bombs have air resistance aswell, very important for horizontal bombbay in h111 and for sure for the light 50kg bombs, which tumbling very much while falling down, and drift easy far away backwards... thats why the bombs allways hit too short ingame...

[V.4_Pogi]

I am using 1440x900 resolution - in the game,the desktop res:1680x1050 - ,and I have found several times in online(for example:ATAG and Repka),the program change itself the resolution 1680x1050 during flying. He does not need a restart, only a moment becomes dark and runs on smoothly,but i change back,he needs the restart then.

[Stirwenn]

Oftenly, i cannot expect my full account of bullets and this even without any damage from ennemy. I kicked the ass of the ground crew with no result. When i count in seconds, i usually have 8 seconds of fire. Short, insn't it ?

[klem]

Originally Posted by V.4_Pogi

I am using 1440x900 resolution - in the game,the desktop res:1680x1050 - ,and I have found several times in online(for example:ATAG and Repka),the program change itself the resolution 1680x1050 during flying. He does not need a restart, only a moment becomes dark and runs on smoothly,but i change back,he needs the restart then.

Try hand editing the [window] section if your conf.ini file:-
C:\Users\[yourname]\My Documents\1C Soft Club\conf.ini

Set the resolution there and see if it sticks:

[window]
DepthBits =24
StencilBits=8
; DrawIfNotFocused=01
DrawIfNotFocused=1
SaveAspect=0
Render=D3D10_0
width=1440
height=900
ColourBits=32
FullScreen=1
ChangeScreenRes=1
Frequency=60
posLeft=0
posTop=0
StereoMode=0

I don't think the parts in italics affect this. You should try the parts in bold font.

[V.4_Pogi]

Originally Posted by klem

Try hand editing the [window] section if your conf.ini file:-
C:\Users\[yourname]\My Documents\1C Soft Club\conf.ini

Set the resolution there and see if it sticks:

[window]
DepthBits =24
StencilBits=8
; DrawIfNotFocused=01
DrawIfNotFocused=1
SaveAspect=0
Render=D3D10_0
width=1440
height=900
ColourBits=32
FullScreen=1
ChangeScreenRes=1
Frequency=60
posLeft=0
posTop=0
StereoMode=0

I don't think the parts in italics affect this. You should try the parts in bold font.

Yes,so for me,withdraw the ChangeScreenRes.

I was use the game in Pseudo mode from beginning - to the ATI card this
recommended.

ChangeScreenRes=0 Fullscrenn OFF

ChangeScreenRes=1 Fullscrenn ON

ChangeScreenRes=2 Pseudo mode

I try your proposal,helps maybe. Thanx.