![]() |
|
IL-2 Sturmovik: Cliffs of Dover Latest instalment in the acclaimed IL-2 Sturmovik series from award-winning developer Maddox Games. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Can you tell which config file I should check? DX9/DX10
|
#2
|
|||
|
|||
![]()
I can tell you where to look but cannot remember the exact text for DX9. But at least you can check that it does not read the same as the line highlighted below (which is for DX10).
Open the file named 'conf' using notepad, you will find it in: MyDocuments- 1CSoftClub - IL-2 sturmovik cliffs of dover. [BOB] EpilepsyFilter=0 [window] DepthBits =24 StencilBits=8 DrawIfNotFocused=0 SaveAspect=0 Render=D3D10_0 |
#3
|
|||
|
|||
![]() Quote:
Render=D3D9 Interestingly many of these settings files are also in C:\Program Files\Steam\SteamApps\common\il-2 sturmovik cliffs of dover but there some values are missing. For example all values starting from Render are missing from conf.ini in this Program Files\... folder. [window] DepthBits =24 StencilBits=8 DrawIfNotFocused=0 SaveAspect=0 Render=D3D9 width=1600 height=900 ColourBits=32 FullScreen=1 ChangeScreenRes=1 Frequency=60 posLeft=0 posTop=0 |
#4
|
|||
|
|||
![]()
The config files were changed two patches ago, removing a lot of redundant settings that had been left there during the development process.
People that first installed the sim recently (that is, after the previous patch near the end of May) already have the config files that have the new structure. Those that installed before that probably have the old config files. If you want to get the new config files you can try this: http://forum.1cpublishing.eu/showthread.php?t=23971 |
#5
|
|||
|
|||
![]() Quote:
![]() |
![]() |
|
|