Trim control Me-109 not working - Page 2

JG53Frankyboy · #11 04-03-2011, 12:55 AM

try your settings without anthropomorphe filter.
If they than work without proplems....

i have it disabled after the first day and will never touch it again if possible.
I had the proplem that the elevator trim whell on my HOTAS watch jikning a little bit - wow, the game thought the pilot had his left hand always on the trimmwheel - so, most other functions didnt work in that time.

huckster · #12 04-03-2011, 01:49 AM

depending on the aircraft you cannot deploy flaps/ gear unless you're below a certain speed iirc, with the 109 you have to hold down the flaps key to lower them and that can take a while as the flaps are dropped/ raised by a wheel.

Hellbender · #13 04-03-2011, 01:55 AM

Also no trimming possible in the BF 109, however in Bombers it´s working, like in the Do 17.

III/JG11_Simmox · #14 04-03-2011, 03:55 AM

regarding the 109
i found it was inop in quick missions only,a bug im sure
in campaign mode the trims and other sliders are working

Kozi · #15 04-03-2011, 10:03 AM

The elevator trim and flaps work fine for me in the Bf 109E-3 (in quick missions OK too).

I use a Thrustmaster Warthog and have the elevator trim mapped to an axes on the throttle. To set the flaps I just hold the keyboard key down and yes it does take a while to fully raise or lower flaps in a 109.

PomFritz · #16 04-03-2011, 10:22 AM

@JG53Frankyboy: canceled the anthropomorphe filter for my Geforce GTX 460 but still the same problems.

@huckster: When i started the german campaign i couldn't even raise my gear after take of (109). Also there is no "Screen response" when i press "G" on the Keyboard like it is if i hit i.g. "I" it shows "Engine Start". Strangely Spitfire and Hurrican work just fine.
BTW, forgot to mention i'm on basic engine management, don't know if it makes a difference in that case.

Anyway, thanks for trying to help guys, i very much appreciate that!

Maybe one of the next patches would solve this problem....