|
|
|||||||
| Controls threads Everything about controls in CoD |
|
|
Thread Tools | Display Modes |
|
#11
12-03-2011, 04:40 AM
|
|||
|
|||
Try this.......copy and paste the following entry at the end of your confuser.ini file (or under 'Hotkey pilot move' if it already exists) which can be found in the 1csoftclub - IL2 Cliffs of Dover installation folder. Then load CLOD and see if the stick axis and rotaries are recognised in the sensitivity bars in the controller set up screen. I read a post some time ago where a member installed his X52 using this method.
[HotKey pilotMove] Joystick+AXE_RZ=1rudder Joystick+AXE_RY=1trimelevator Joystick+AXE_RX=1trimrudder Joystick+AXE_Z=-1throttle Joystick+AXE_Y=1elevator Joystick+AXE_X=1aileron Joystick+AXE_U=1radiator
__________________
MP ATAG_EvangelusE AMD A8 5600K Quad Core 3.6 Ghz - Win 7 64 - 8Gb Ram - GTX660ti 2Gb VRAM - FreeTrack - X52 - Asus 23' Monitor. Last edited by SEE; 12-03-2011 at 04:43 AM. 
|
|
|
Threaded Mode