Anyone tried more than 3 controllers?

[tf_neuro]

4 controllers here: works fine.

CH Fighterstick
CH Pro Pedals
CH Throttle Quadrant
+ the Throttle off an old x52

Not using any special software, just plugged everything in.


As for the throttle problem

I have one an dit works with only one problem, the slider that I use for throttle goes from 0 to full using only the first +/- 30% of the slider.

-Go to the controls settings interface, axes tab
-Select throttle.
-At the bottom of the page, you will see 5 sliders (left side) and 2 indicators (right side)
-On the right side, the 'in' is your throttle movement, 'out' is what the game does.
-Now, on the left side, set the five sliders like this (top to bottom)
slider#1 = 0.02
slider#2 = 0.00
slider#3 = 1.00 <= All the way to the right
slider#4 = 0.00
slider#5 = 0.02

- This will give you a small dead zone at both ends just to make sure that the output (i.e. 'what the game does') actually goes all the way down to 0 and up to 110 (this is set in the first and last sliders), and the slider#3 at 1.00 sets the in-game throttle to follow your controller throttle instead of jumping up abruptly.

Hope that helps.

PS: use as guidelines, not as ...'gospel'