Quote:
Originally Posted by bolox
You have Elite pedals , correct? (and yes they are rather nice  )
AFAIK they will only connect to specific Thrustmaster HOTAS, eg Cougar.
The wiring of the pot may also be problematic if you try to attach to a Bodnar board (or similar) as it uses a 2 wire system, rather than a 3 wire 'voltage divider' circuit used by these. |
The pedal linked in Craiglist is the
Tm RCS, prior of Tm Elite.
I dont find problem to wire one in modern USB controller, just is not "PnP".
As noted is need use 3 wires instead 2, and I did it using original cable:
The cable external shield net is now GND wire.
The pot in picture is original Tm - later replaced by a HALL Sensor.
In this small box fit the new USB controller - a
DIY Mjoy8.
To interface the USB box with computer use a ordinary USB A/B printer cable.
A similar approach can be done with BU0836 or similar.
BTW - In the original form this pedal have only one axis, no brakes axis.
Sokol1