View Single Post
  #8  
Old 12-03-2011, 04:40 AM
SEE SEE is offline
Approved Member
 
Join Date: Oct 2009
Posts: 1,678
Default

Try this.......copy and paste the following entry at the end of your confuser.ini file (or under 'Hotkey pilot move' if it already exists) which can be found in the 1csoftclub - IL2 Cliffs of Dover installation folder. Then load CLOD and see if the stick axis and rotaries are recognised in the sensitivity bars in the controller set up screen. I read a post some time ago where a member installed his X52 using this method.


[HotKey pilotMove]
Joystick+AXE_RZ=1rudder
Joystick+AXE_RY=1trimelevator
Joystick+AXE_RX=1trimrudder
Joystick+AXE_Z=-1throttle
Joystick+AXE_Y=1elevator
Joystick+AXE_X=1aileron
Joystick+AXE_U=1radiator
__________________
MP ATAG_EvangelusE

AMD A8 5600K Quad Core 3.6 Ghz - Win 7 64 - 8Gb Ram - GTX660ti 2Gb VRAM - FreeTrack - X52 - Asus 23' Monitor.

Last edited by SEE; 12-03-2011 at 04:43 AM.
Reply With Quote