Quote:
Originally Posted by IvanK
Just went and tested this issue specifically. Attempting to simulate exactly what David198502 did in his video. I agree David198502 The E4 Prop pitch is moving in both AUTO and MANUAL at exactly half the rate that it is moving in the E1 and E3. In my case I don't get any sudden slow down its just to slow all the time. ... looks to me like the old too slow prop pitch code from 2 Betas ago
The E4 in both AUTO and MANUAL is taking 12 seconds for 1 hour of Clock indicator.
The E3 and E1 takes exactly 6 seconds for 1 hour of Clock indicator.
As to the Pitch continuing to move after release of the button. This occurrs in the E1 and E3 as well and I think simulates a certain amount of inertia. In the case of the E4 this is worse as I think its being over emphasised by the half rate prop pitch chahnge.
DEVS have been informed directly.
As to the problem with it getting Stuck at 8:30 (full coarse position) I cannot replicate that. At 730KMH At low level at IDLE ATA the Pitch indicator is showing FULL COARSE at the 8:30 position. The instant I select Higher ATA the Prop starts fining up at the slow rate.
Since demanded ATA determines RPM and Prop pitch being at High Speed Low ATA is not a good place to be if you intend to zoom. If that is the plan then you need to get the ATA and therefore RPM up before you start the zoom.
|
Good to hear.
have you taken them to task over the auto radiators?
