|
|
#6
12-14-2015, 05:23 PM
|
||||
|
||||
FI software entries
Excellent reply Storebror, was hoping some one would throw the dog a bone!
I needed something to naw on! Now just need to figure out how to apply your information. I sent an e-mail to FI tech support, but unfortunately their tech support is not as good as their product! Hopefully they will reply. I have 9 gauges working, but the turn/slip one is a bit different. Here is what their software looks like for turn/slip...... [IMG]  [/IMG]FI- had min value -1000 & max 1000 , I changed to -1 & 1 , but no joy. [IMG]  [/IMG][IMG]  [/IMG]This is were the problem may be with understanding how to set values to needle movements!!!! Can use anywhere from 3 to 20 needle values. [IMG]  [/IMG]Needle has position numbers , values per position? Last edited by Windturbin; 12-14-2015 at 07:16 PM. Reason: Links 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode