Strange video settings problem

[GF_Mastiff]

you may want to just have the il2 setup on with flat shadows that helps me spot the object better lighting flat and object lighting flat try that also the higher the AA and ANTI
the better the fps for Open gl you will get. Thats from my experience.

[rakinroll]

Tried low anti aliasing, flat ground and object lightnings, lower shadow setting (shadows=0), disabled the S3TC-Compression settings but those planes still disappearing... What i am missing?

[dflc03]

Originally Posted by rakinroll

... What i am missing?

One good nVidia card?

[GF_Mastiff]

Originally Posted by rakinroll

Tried low anti aliasing, flat ground and object lightnings, lower shadow setting (shadows=0), disabled the S3TC-Compression settings but those planes still disappearing... What i am missing?

heres my setting in ATI CCC

[brando]

Yes, but do note that the x1950 Pro support stops at Catalyst 7.11. Beyond that date the frame rates are cut by almost half.

B

[rakinroll]

Thank you gentlemen, i have very good system (AMD X2 5.6 Dual - 3 x 1 Gig DDR 2 RAM - Asus AMD Chipset Mainboard - Ati Radeon Saphire X1950 Pro 512 Mb PCI2 Video Card) but seems not enough for IL-2 or i am doing somethings wrong here. Please post here if you guys find a way to get better visibility for my system. S!

[Feuerfalke]

I think brando is right.

I don't know much about ATI-settings and the CCC, but if you look at your screenshots, it says:

"Graphicsadapters: 1. HD 3600 Series..."

Yet you have a X1950.

You got the wrong drivers installed. Remove them, use DriverCleanerPro (Freeware) to remove the settings and install Catalyst 7.1 drivers and test it again.

[GF_Mastiff]

Originally Posted by Feuerfalke

I think brando is right.

I don't know much about ATI-settings and the CCC, but if you look at your screenshots, it says:

"Graphicsadapters: 1. HD 3600 Series..."

Yet you have a X1950.

You got the wrong drivers installed. Remove them, use DriverCleanerPro (Freeware) to remove the settings and install Catalyst 7.1 drivers and test it again.

those are my screen shot's, that's what I have in crossfire mode, no problems with IL2 avrg 50 to 70 FPS

[Zoom2136]

Originally Posted by rakinroll

Thank you gentlemen, i have very good system (AMD X2 5.6 Dual - 3 x 1 Gig DDR 2 RAM - Asus AMD Chipset Mainboard - Ati Radeon Saphire X1950 Pro 512 Mb PCI2 Video Card) but seems not enough for IL-2 or i am doing somethings wrong here. Please post here if you guys find a way to get better visibility for my system. S!

Check out Costies website for info on setting up ATI cards... Its a step by step guide... and you will be all set...

[GF_Mastiff]

Originally Posted by brando

Yes, but do note that the x1950 Pro support stops at Catalyst 7.11. Beyond that date the frame rates are cut by almost half.

B

I don't see why is it a agp or PCIe card? I had 2 X1650 pros running with no problems and I had the same FPS avrg of 30 to 70 for IL2. With the new 8.4 CCC drivers installed.