4.11 General debugging

[panzer1b]

i was just flying some russian planes in a new mission i was testing, and i came across a fairly huge bug in the yak-7 series

their center of rotation when u pull up is for some reason behind the wings whereas i would believe it should be located more forward like the picture shows

please go into a yak7 (any of them all same problem), and try to pull up or do any elevator motion and notice how the plane doesnt rotate about what would be its center of lift (eg near the wings most likely above them) like all other planes, but instead rotates about a spot behind the wings

also look into the plane choosing window (like advanced loadout section) and notice how it rotates about this weird spot behind the wings, while all other yaks rotate around somewhere near the wings. Although im not a expert or even any good at 3d modeling, im guessing the model's center point determined when its compiled or something determined about what spot it rotates when well rotating or pulling up/down. And the way is now just doesnt make sense. Not sure if someone compiled the center's location right or something but im guessing move it to the green area in the attatched pic

i would reccomend making the yak7s act just like the rest of the yaks instead of the way they are

if this is intended then just disregard this, but i do believe it is not suppost to be this way