109 engine load vibration

[5./JG27.Farber]

Keep the oil about 80 or less, water 100. Do not exceed 90 oil and 115 water but it depends on altitude, higher you go the lower the figures... and dont let it go over 2600 rpm and definatley not over 3000 rpm. Also dont keep the Ata over 1.4 for too long.

Sounds to me its the start of an overheat or engine failure. Does it happen usally in a hard climb or when open throttle and boost on? When I leave the ata over 1.4 for a while my 109 will shake sometimes even though temps are fine. Just throttle down to under 1.4

[CaptainDoggles]

I haven't watched the video but with the throttle wide open in a slow, steep climb I get bounced around a noticeable amount.

I think it's just part of the simulation, and also probably an indicator that you're pulling too much AoA.