Setting up Sli

[Bokononist]

Originally Posted by katdogfizzow

Didn't work with my Gigabyte 460s. Still the slow and jittery fps mess. Also did C/P = CPL_HIDDEN_PROFILE_DISABLED, Enable application for Optimus = 0x00000011 and "PhysX settings" = cpu

thanks for sharing, looks like my hardware is a no go with this profile

Same here, two 460's, I've got all the same settings, created a custom profile for Launcher.exe and it doesn;t seem to have an effect, one card going like the clappers @99% and the other between 10 and 14%, it's not a 'jittery mess' but if its working for others I'd like to join the party! What can I have missed?
I'm new to SLI so maybe it's something obvious, any suggestions gratefully recieved. SLI is enabled in nvidia control panel and works like a beast with every other game.
Also, when the official SLI profile becomes available will it automaticaly take precedence or will I have to delete my custom profile?
Thanks in advance,
Boko.

[RickRuski]

Hi Bokononist,

Check your Nvidia CP, see if you have one of your cards set for "Physics". If the answer is YES change it to CPU in the settings. Also each time before you go into COD set your "Inspector" to the correct profile (it tends to reset to "Global") and then "Minimise" Inspector, don't turn it OFF. See if this helps. The reason for this Physics setting see my edited profile settings (28/9/11)

Rick

[Bokononist]

Thanks mate, all working fine now, 60% each card now rather than 99/10!
Your time and suggestions are very much appreciated.

[Ataros]

Originally Posted by Bokononist

Thanks mate, all working fine now, 60% each card now

Why is it only 60%? Does not CloD need more with maxed out settings and res?

[Bokononist]

Originally Posted by Ataros

Why is it only 60%? Does not CloD need more with maxed out settings and res?

Probably because this is a 'make-do' profile and not the official version, when official driver support comes in we'll see what happens.
Until then things are running better, and my top 460 doesn't have to run at 99% for hours on end!

[RickRuski]

Hi Chris455,

If there is no profile "Cliffs of Dover" or "Launcher.exe" make a new profile as Cliffs of Dover using the one I have suggested. Also see my reply to Bokononist as to setting "Inspector" and "Nvidia Control Panel".

Sorry for the slow reply.

Cheers

Rick

[15.Span_Valalo]

Hi Guys. Hi RickRuski

I did what you had ordered, but in my case, the SLI works but I have many stoppages in the cities ... I I have done the same profile that you are using physic CPU and SLI is turned on ....

I have 2 target in SLI (GTX 275) on ASUS P6T motherboard with 6gb ram trichannel and microprocessor is I7 at 2,8....

My FPS is in the water 60, the game runs fine, but in cities ... fps is very poor ... The levels of detail in cities and forests are very low and medium quality textures ...

Any ideas.

Thank you.