Control sensitivity

OK, even with the RZ (rudder) axis values set very low it is still very sensitive.
Little to no change with this I'm afraid. If anyone comes up with anything new let us know!

Well, it seems possible that the above config edit did work, though not for all aircraft. The hurricane fells much more stable now but the spitfire feels twitchy as ever. I'm not sure exactly what is happening here, I hope someone with more knowledge of the games inner workings can fill me in.

[Extreme_One]

I wish we had curves as we did in the previous game.

[Luftwaffle]

Mine is opposite, my axis are too slow! Can't figure it out..

Originally Posted by Extreme_One

I wish we had curves as we did in the previous game.

This...

OK, I got it figured out! I was on the right track but what I failed to realize was that my 1946 was on a fresh install and I hadn't set up my controller for it yet. After I set up my controller in 1946 I went into its config file and sure enough the proper values were now in there. I simply copied and pasted from the 1946 config to the CoD one. Here is what it looks like:

[rts_joystick]
X=0 1 4 9 16 25 36 49 64 81 100 0
Y=0 1 4 9 16 25 36 49 64 81 100 0
Z=0 10 20 30 40 50 60 70 80 90 100
RZ=0 10 20 30 40 50 60 70 80 90 100 0
FF=0
U=0 10 20 30 40 50 60 70 80 90 100 0
V=0 10 20 30 40 50 60 70 80 90 100 0
1X=0 1 6 10 15 22 33 44 58 72 100 0
1Y=0 1 6 10 16 23 31 43 56 73 100 0
1Z=0 100 100 100 100 100 100 100 100 100 100 0
1RX=0 100 100 100 100 100 100 100 100 100 100 0
1RY=0 100 100 100 100 100 100 100 100 100 100 0
1RZ=0 1 4 8 13 21 28 39 52 69 100 0
1U=0 100 100 100 100 100 100 100 100 100 100 0
1V=0 100 100 100 100 100 100 100 100 100 100 0

This, everyone, I have confirmed to work! You need the 1X values for it to work not the X values, the axes with the 1 infront are what windows uses to set the joystick sensitivity.

Perhaps this should be stickied so everyone can benefiet from this.

[jimbop]

Doesn't make a difference for me. What is your stick listed as (i.e. Joystick or Joystick1) in the relevant control menu?

[SEE]

Doesn't the in game axis sensitivity slider work for you? Seems to work with my x52.

Originally Posted by jimbop

Doesn't make a difference for me. What is your stick listed as (i.e. Joystick or Joystick1) in the relevant control menu?

Not sure what you mean, It shouldnt make any difference so long as the values are placed in the right config under the right line [rts_joystick]. It has made a massive improvement for me, I consider the sim playable now without getting carpal tunnel in the first ten minutes.

What stick are you using? Worked fine for my X-52.

[Extreme_One]

Originally Posted by Formula88

OK, I got it figured out! ...

I'll test this out in the next day or so and report back.