Modded my X52 pro - it's another stick!!

[Sokol1]

X-52/PRO and even X-65F use HALL only in X and Y axis, throttle and rotaries use pots.

If the maker dont offer replacement is difficult change pots, since stick use pots with 60, 90
degrees for course, diameter and length of axis in many cases are specifics.

Fortunately is relative ease replace pots with DIY HALL sensor assembles.

Sokol1

[klem]

Well I have a long standing technical background but its a bit out of date.

1. Can I simply buy the 'right' hall sensor and wire it in in place of the pot or 2. Does it need some kind of interface/driver?

If the answer to question 1 is Yes, where do I get the sensors and magnets?
If the answer to question 2 is Yes, well I guess that's a dead idea