Start Engine? Probable solved
 

To start the engine I would like to use one key but can not find what key that is. Below is what thy say--------- but not were or what key to use to reset this.:confused:
Anyone know?

Thanks,
flyer01



Another important constraint enabled by this option is what was in previous
titles called a (Separate Engine Start) option. This option is independent of
the Complex Engine Management settings. Pilots in real multi-engine aircraft
had to start up each engine separately. With Anthropomorphic Control
option disabled you will be able to start up all aircraft engines with a single
key. Otherwise you will need to individually select and start up each engine
in turn.

I

just press the start key is not enough with CEM activatet.
The key setting is there, but it does not start the engine alone if you not before had activated the fuel, manipulatet the mixture, activated carburetor heating.

The planes in general behave different :D
-> http://forum.1cpublishing.eu/showthread.php?t=20321

Hay thanks, any other talk about this is great.

flyer01

What is the name of the key command and where is it in the controls panel?

thanks

flyer01

Bump.
I can not get the plane to start to take off.
What key do you use to start the engine? "I" is not any where in the air-plane controll panel.

thanks,

flyer01

Its in the aircraft category: Toggle selected engine(s) = I

I do not have Toggle selected engine(s) in the command aircraft.

Probable solved! I did have that command and found it.

I was looking in the engines commands toward the bottom of the list.

Thank you very much!


flyer01