#561
|
|||
|
|||
Quote:
Make sure you have all the filter boxes checked in the FMB I see no Russian supply columns only moving armour and artillery. Axis supply German supply column Type II B-2 to C-3 Fuel supply column D-7 to E-6 Last edited by KG26_Alpha; 04-02-2013 at 05:09 PM. |
#562
|
|||
|
|||
Is there a posibility that bomb set to low-level 4 s. delay will explode immediately after hit the ground? Is there some kind of failure for the bomb fuze? My approach was about 1000m alt, 30 deg. flat dive. I droped the bomb 180m over the ground and my speed was 580km/h. Aircraft - P-40M with 1000lbs bomb.
|
#563
|
||||
|
||||
About FMB.
A lot of .mis files are impossible to laod with the 4.11.1m FMB.
Is't a know bug? |
#564
|
|||
|
|||
It is a corrupted mission. Possibly edited outside FMB? Change "gust 4" to "gust 0" and it will load.
|
#565
|
||||
|
||||
Quote:
Wich allowed value for Gust and Turbulence parameters? From 0 to? |
#566
|
|||
|
|||
B1-6 Unlimited Fuel Bug
Uh oh. I think this has been around for a bit, but even with NO FUEL, the ramjets on the B1-6 offer unlimited power.
Yikes. They never run out of gas. |
#567
|
|||
|
|||
Still Multi-Engine Problem (no one responded)
Track:
http://files.tolwyn.com/engine_weirdness2.ntrk This makes using engine 1/2/3/4 select an impossible issue. Introduced in 4.11: DISABLE manual view so you can watch what I'm showing. Deselect both engines Show that both are deselected Select engine 1 Start engine 1 Deslect engine 1 Select engine 2 Start engine 2 Select both engines, bring throttle to idle This is "normal starting position" DESELECT engine 1 (conversely, enable only engine 2) Bring engine 2 to idle Feather engine 2 Shutdown engine 2 DESELECT engine 2 (we don't need it anymore) SELECT engine 1 Show that engine 1 is selected (throttle up, then throttle down, etc.) Bring engine 1 to 70% power; note that all is fine. SIMPLY DESELECT engine 1 (essentially NO engines are selected at this point) Watch the RPMs climb in engine 1 Repeat tests. You can easily get engine 1 to fail by simply deselecting it and not changing any other parameters. |
|
|