#1
|
|||
|
|||
E4 CEM since patch
Forgive me for being a bit lazy here but I haven't had much time for this game lately.
I've played online maybe 3 quick times since the new patch and decided to be lazy and take the E4 with auto prop pitch as I'm out of practice. I've had my radiators open fully, encountered an enemy, closed radiators to half, engaged the WEP done a spiral climb and in a few seconds windscreen is covered in oil. Got fed up and quit the game. I've just got too much going on to invest into going full nerd with this game as I used to do. So I thought can someone please explain what has changed in CEM and what I did wrong? I think I also noticed that opening the water radiator fully didn't seem to change the coolant temp at all whilst cruising over the channel. |
#2
|
||||
|
||||
3/4 is enough in all case, the half is too few (the water will slowly boil), the full is too much (slows the plane 10-20 km/h). Use wep only in emergency. Hope it helps
__________________
| AFBs of CloD 2[/URL] |www.pumaszallas.hu i7 7700K 4.8GHz, 32GB Ram 3GHz, MSI GTX 1070 8GB, 27' 1920x1080, W10/64, TrackIR 4Pro, G940 Cliffs of Dover Bugtracker site: share and vote issues here |
#3
|
|||
|
|||
Did you open the oil cooler aswell?
|
#4
|
|||
|
|||
The CEM of the E-4 is wrong from the beginning. If you throttle down your RPM goes down and Ata stays by 1,3, which is wrong and would kill your engine in real life.
Ata and RPM should get reduced by reducing throttle. A little example: Your fly with 1,45Ata (1-min. power = emergency full throttle) with 2468 rpm and you reduce your throttle to 1,35Ata 5-min. power(full throttle) then rpm goes automatically down to 2368 rpm and hold them. If you reduce the throttle down to 1,30Ata then rpm will level off by 2326 rpm. And so on. Or else the manuals for the Bf 109 and Bf 110 (I think it was a Bf 110 manual/will search it later) wouldn't make any sense when they write "when in automatic mode fly after Ata settings". |
#5
|
|||
|
|||
OK, the text says "Fly regarding to rpm, observe manifold pressure as control."
bf 110 E auto rpm-pressure.jpg Source: "D.(Luft) T.2416/1 Bf 110 E mit 2 Motoren DB 601 A oder DB 601 N - Kurzbetriebsanleitung" from Oct. 1940 Last edited by Kodoss; 11-06-2012 at 07:00 PM. |
#6
|
|||
|
|||
|
#7
|
|||
|
|||
Quote:
In addition reducing RPM before ATA (though not a good practice IRL) wont necessarily damage the engine unless you reach some detonation threshold of low rpm v ATA. I dont see how you can do this anyway in AUTO. As to the statement ""Fly regarding to rpm, observe manifold pressure as control." what is your interpretation of this in terms of practical pilotage with AUTO in operation ? Are you saying the pilot uses the throttle to set an RPM and just accepts the ATA rather than setting an ATA and accepting the RPM ? ... I can sort of see the logic in this but only in an AUTO CSU system. The convention with a standard (Non AUTO CSU) is to set ATA/BOOST/MAP to a desired value then set the desired RPM ... ideally with RPM leading the Boost on the way up and lagging on the way down. Last edited by IvanK; 11-06-2012 at 09:29 PM. |
#8
|
|||
|
|||
yep oil and water both set on 1/2 just like I've always done in this sim.
|
#9
|
|||
|
|||
Quote:
If you are in a hard climb and your airspeed drops below 250ish you need to open rads or you will overheat quickly. Using WEP will aggravate it more as will higher alt. |
#10
|
|||
|
|||
There's some sort of bug with the E-4 auto prop system - namely that by default it just doesn't work. Dis-engaging AUTO and adjusting the propeller angle manually a bit and then switching back to AUTO fixes it though... >/
__________________
Il-2Bugtracker: Feature #200: Missing 100 octane subtypes of Bf 109E and Bf 110C http://www.il2bugtracker.com/issues/200 Il-2Bugtracker: Bug #415: Spitfire Mk I, Ia, and Mk II: Stability and Control http://www.il2bugtracker.com/issues/415 Kurfürst - Your resource site on Bf 109 performance! http://kurfurst.org |
|
|