![]() |
|
Gameplay questions threads Everything about playing CoD (missions, tactics, how to... and etc.) |
![]() |
|
Thread Tools | Display Modes |
#121
|
|||
|
|||
![]()
Good to know, i'll try it out next time i'm flying that temperamental coffin
![]() I have all the bombsight functions mapped to my numeric keypad with shift and ctrl combinations, i'll have a look at it. Also, thanks to IvanK for the renewed feedback ![]() |
#122
|
|||
|
|||
![]() Quote:
Quote:
Regarding the de Havilland two position propeller on the Spitfire I: "If the two position control is fitted on this aeroplane it can also be operated to give various airscrew pitch settings between fine and coarse; this is obtained by slowly moving the control between its range of movement until the desired r.p.m. are obtained. […] This in effect will give a similar improvement in performance to that obtained by means of a constant speed airscrew." Are the devs aware of this? Hmm, come to that; are the devs aware that Spitfire Is were equipped with constant speed propellers during the Battle of Britain? Last edited by lane; 10-01-2011 at 01:41 PM. |
#123
|
|||
|
|||
![]()
"Are the devs aware of this?
Hmm, come to that; are the devs aware that Spitfire Is were equipped with constant speed propellers during the Battle of Britain? " Yes the Devs are aware of both these facts. |
#124
|
|||
|
|||
![]()
Thanks for the feedback IvanK. What is the likelihood that the simulation will be corrected by the developers to more accurately reflect the Spitfire I’s condition and performance during the Battle of Britain by incorporating these facts into the flight model?
|
#125
|
|||
|
|||
![]()
It will be fixed just not sure exactly when.
|
#126
|
|||
|
|||
![]()
Hello,
Could'nt get abouve 10 k ft conveniently, first of all above that, you have a very small margin to operate the boost, 2 lb is OK, more and you over-heat, less and it shakes. Is it a problem with the sim ? At lower altitudes, it behaves correctly however it gets very warm aith bosst of 4 lb. In previous posts someone sais boost 5 lb for climb. How do you get that high a boost without overheating ? |
#127
|
|||
|
|||
![]()
Been tackling the might Blenheim. Read that lowering fuel load is a good idea. My slider is locked to 100%, is this a recent bug?
Also I am unable to select type of bombs to load. |
#128
|
||||
|
||||
![]() |
#129
|
|||
|
|||
![]()
Hi guys, i have spent quite a while in the blenheim today and managed to get 13000ft out of it before getting bored. Above about 9000ft though engine management is a nightmare as the engines misfire between 55 and 65% power. running more power they overheat, less power you cant fly. my solution was pitch 0% and power to max above 11000ft. seems to work ok but you dont have much power to play with. also oil temp drops to about 20 which is rubbish. I have no idea why they missfire at mid power. Mixture dose nothing at all. (mix could be stuck full rich, this would explain the misfire)
Also the boost cut out seems to work fine, to get it to kick in however you must throttle back to 80% or so, select it, and then back to full power. it should show as 110% if you have the info window up. Having also had a play with the BR20 today (the CEM in the BR20 works a treat btw) and i think its possible that the radiator areas are misassigned for the blenheim. That is on the blenheim you cant get the oil to 80-90'c because it could have been assigned the larger cooling area of the engine. The engines on the other hand always run hot because they have been assigned the small cooling area of the oil cooler. I could be wrong, but it would explain alot! |
#130
|
|||
|
|||
![]()
Also, i just remembered that you cant get anywhere near the 2750rpm on the ground that the pilots notes for the real aircraft say you should get. this also means all the climb power rpms are unobtainable as well.
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|