Water settings.....

[Zeke Wolff]

Originally Posted by Prowlinger

1. Can you ramp a height from point A to point B with the heights brush?

Yes you can... but I wont tell...

Nah, just kidding. Place the brush on top of the hill (or wherever you want the "ramp"). Then hold LSHIFT and then move the mouse whilst holding down the RMB. This will create a quite good slooping ramp. It will take a few (ok, many in some cases) moves with the mouse to get it nice though.

Originally Posted by Prowlinger

2. Is there a command to "smooth an area" instead of settings the brush to the lowest settings it will go and brushing down height 1 time?

As far as I know... nope. I always smooths my maps with the LSHIFT-LMB and LSHIFT-RMB. You can enlarge the brush with the "+" and decrease it with "-". With a very large brush you will smoth a 500x500 sized map in no time.

Originally Posted by Prowlinger

3. Can you explain what the 4 borderlines exactly do?

I´m not 100% sure on this myself but ok, here is what I know about them.

Originally Posted by Prowlinger

YELLOW = Player units max distance... (Seems AI can go beyond that?) Fog also starts here and goes to the edge of the green border.

GREEN = Max distance you can see period... Fog ends here.

Your guess is as good as mine.

Originally Posted by Prowlinger

LIGHT BLUE = ???

Really don´t know what this one do.

Originally Posted by Prowlinger

MAGENTA = ???

This tells where the map ends. You can´t move outside this border line if you have the "Clip Camera Position" clicked.

I usually places the magenta line where I want my map to end (in 99% of the cases it is located at the true edge of the visible map). The yellow/green lines is placed so that the green line is about the width of a Tiger I ( ) from the magenta line.

The light blue (cyan?) is located in between the yellow and green lines, but closer to the yellow one.

This seems to work quite good with both MP and SP maps that I´ve made earlier (for FoW and DCG. I haven´t made any MP map for MoW yet).

Originally Posted by Prowlinger

4. When placing textures ... I seem to be having a hard time finding certain textures that blend with one another (when they don't perfectly blend they make hard edge lines)...
Is this just an error in the editor or do you have to find the perfect textures overall?

No, it isnt an error in the editor, it is just you who hasn´t fully understood how the textures work.

This is quite difficult to explain but there is a tutorial which explains this. Last time I saw it, it was still located at the DMS site. Here is a link to the actual tutorial. http://www.digitalmindsoft.eu/forums...php?f=16&t=454

~Zeke.