|
|
|
|
#1
06-12-2012, 07:53 AM
|
|||
|
|||
Spitfire Weathering Excessive at 0%
Hi
Is there a fix for the excessive weathering of the Spitfire when sliding the weathering bar to 0%. I cannot remember that it was that bad. Is there a template or way to get a more factory fresh Spit? The Me 109's on the other hand looks like they were just painted even if at 100% Those bright yellow noses that looks like they had 10 cans of paint roughly applied is also annoying. Man, when will we get all this stuff sorted out. Thank you. G 
|
|
#2
06-12-2012, 08:24 AM
|
||||
|
||||
|
No I don't think there is,apparantly it was rendered like this a couple of upgrades ago.A lot of the regular skinners have complained about this for obvious reasons.
The devs have been notified and hopefully it will be corrected soon,hopefully being the operative word 
__________________
 Alienware Aurora|Win 7 64-bit Home Premium|IC i7-920 Processor (Quad-Core)|14GB DDR3 RAM|1 TB SATA 7200rpm Hard Drive|GIGABYTE GeForce GTX 770 2GB WINDFORCE 3 X fan|Thrustmaster Warthog|Saitek Pro Combat rudder pedals,throttle quadrant and Cessna trim wheel|TrackIR4|Sense of humour,I find it comes in handy!
|
|
#3
06-12-2012, 10:31 AM
|
||||
|
||||
|
Hi Foofighter
Yeah your dead right the Weathering especially on the Spit is OTT. The in game weathering slider makes no differnce as these are Hardcoded Overlays built into the Programming  As Andy says a few of us Skinners have moaned about this and lets hope the guys at 1C take note  Watch this space Regards Keith
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
