Can't load Saitek X52 pro 64bit profile

[335th_GRAthos]

Not quite sure I understand but I can explain how it works with my Saitek and maybe you can find out what you need:

The Profile Editor is used to allocate keystrokes or keystroke combinations to your joysticks.
At the top dropdown menu it always shows which joystick you are currently setting up (X45, throttle, rudders etc etc).
Always select the Joystick picture (in order to be sure you are allocating keystrokes to the joystick you want to use and not to a different joystick tan the one you have) and then proceed to the buttons table.

The Saitek joysticks you have are shown (if properly installed) as small icons on the bottom right of your taskbar. One for each joystick.
In my case, I have four icons: One for X45, one for throttle quadrant, one for second throttle quadrant, one for rudders. The icons are black.
I go with the mouse on top of the icon I want (e.g. X45) I right-click with he mouse and I see the list of available profiles I have created with the profiler.
I select the profile I have preparedfor my X45. The profile loads and the black icon get a green background colour to indicate that a profile is loaded.
I right-click upon the second throttle quadrant icon and I select the profile I have prepared for the throttle quadrant. This icon now also gets a green background.

I have loded the two profile I need (one for the X45 and one for the second throttle quadrant).

IF I load a profile on the wrong joystick e.g. I load the X45 profile on the Throttle quadrant, I get the error message you mentioned.


I hope it helps.

~S~