Fulqrum Publishing Home   |   Register   |   Today Posts   |   Members   |   UserCP   |   Calendar   |   Search   |   FAQ

Go Back   Official Fulqrum Publishing forum > Fulqrum Publishing > IL-2 Sturmovik: Cliffs of Dover > Technical threads > FM/DM threads

FM/DM threads Everything about FM/DM in CoD

Reply
 
Thread Tools Display Modes
  #41  
Old 10-31-2011, 05:17 PM
Robo.'s Avatar
Robo. Robo. is offline
Approved Member
 
Join Date: Sep 2009
Location: Nottingham, UK
Posts: 658
Default

Quote:
Originally Posted by BP_Tailspin View Post
This place never ceases to entertain me …
You just contributed quite a few jokes yourself

Quote:
Originally Posted by BP_Tailspin View Post
Should they have an impact on speed?
Of course.

You're right with a P-51, but completely wrong with a 109 (and Spitfire and Hurricane)

No offence dude
Reply With Quote
  #42  
Old 10-31-2011, 05:20 PM
David198502's Avatar
David198502 David198502 is offline
Approved Member
 
Join Date: Dec 2009
Location: Austria
Posts: 1,536
Default

Quote:
Originally Posted by ACE-OF-ACES View Post
Since David was unable, or unwilling to provide the real 'data' his claim is based on, I figured I would give it a quick look.

To see what all the fuss is about, ie are we talking about

10?
20?
30?
40?

In doing so I found some 109G data but not E data, here is the sorce

http://www.wwiiaircraftperformance.o...9/14026pg9.jpg

Now it is really hard to read the speed axis, but it 'looks' like it goes

520
530
540
550
560

If that is the case, than the 'difference' in speed between open and closed is..

5 kph

Which is well within the pilot error noise

Thus, IMHO, the only way to detect this small change is to log the data and account for the pilot errors

PS correct me if I am wrong, but the rads on the 109 changed alot from the E to the G, so, assuming Jerry did a better job on the new rads, we can only assume that the older E rads caused more drag, and thus impacted speed more. But, even if the change was doulbe this, say 10kph, it is still well within the pilot error noise
well that document is really hard to read....however how do you come to the conclusion of 5kph differnce?

maybe i read it wrong....there are two different graphs which show the speed per rads setting.
however both show a straight decreasing line with the same angle...so the difference remains the same.
the lower line shows a speed of 555kph with 50mm opened rads, and only 505kph with 310mm opened rads(which is not fully open).

50kph difference between not fully closed and not fully opened rads...
__________________

Last edited by David198502; 10-31-2011 at 05:33 PM.
Reply With Quote
  #43  
Old 10-31-2011, 05:43 PM
ACE-OF-ACES's Avatar
ACE-OF-ACES ACE-OF-ACES is offline
Approved Member
 
Join Date: May 2010
Location: NM
Posts: 2,248
Default

Quote:
Originally Posted by David198502 View Post
well that document is really hard to read....however how do you come to the conclusion of 5kph differnce?

maybe i read it wrong....there are two different graphs which show the speed per rads setting.
however both show a straight decreasing line with the same angle...so the difference remains the same.
the lower line shows a speed of 555kph with 50mm opened rads, and only 505kph with 310mm opened rads(which is not fully open).

50kph difference between not fully closed and not fully opened rads...
As noted, hard to read the graph, but assuming 'speed' is on the bottom (x axis) and that it goes as follows

520 - 530 - 540 - 550 - 560

Now looking at the point where the two curves intersect (y=0) the bottom (x axis) we have

1st @ ~523.5kph
2nd @ ~528.5kph

5 = 528.5 - 523.5

That is what I got, but again, I could be reading it wrong too.. That graph is hard to read

But..

Lets not use that graph.. Lets use the 109E data your claim was based on! That would be the correct thing to do! Now that I got your att on the subject!
__________________
Theres a reason for instrumenting a plane for test..
That being a pilots's 'perception' of what is going on can be very different from what is 'actually' going on.
Reply With Quote
  #44  
Old 10-31-2011, 05:46 PM
BP_Tailspin BP_Tailspin is offline
Approved Member
 
Join Date: Oct 2007
Posts: 170
Default

Quote:
Originally Posted by Robo. View Post
You just contributed quite a few jokes yourself



Of course.

You're right with a P-51, but completely wrong with a 109 (and Spitfire and Hurricane)

No offence dude
Jokes? What jokes?

What did I say that was wrong with a 109?

"No offence dude" none taken

Last edited by BP_Tailspin; 10-31-2011 at 05:48 PM.
Reply With Quote
  #45  
Old 10-31-2011, 05:55 PM
David198502's Avatar
David198502 David198502 is offline
Approved Member
 
Join Date: Dec 2009
Location: Austria
Posts: 1,536
Default

Quote:
Originally Posted by ACE-OF-ACES View Post
As noted, hard to read the graph, but assuming 'speed' is on the bottom (x axis) and that it goes as follows

520 - 530 - 540 - 550 - 560

Now looking at the point where the two curves intersect (y=0) the bottom (x axis) we have

1st @ ~523.5kph
2nd @ ~528.5kph

5 = 528.5 - 523.5

That is what I got, but again, I could be reading it wrong too.. That graph is hard to read

But..

Lets not use that graph.. Lets use the 109E data your claim was based on! That would be the correct thing to do! Now that I got your att on the subject!
the whole document is twisted 90° left.
so the speed is actually on the y axis.but there is also the temperature on the y axis as well in the lower half...
and the rads settings are on the x axis in mm.

so the doc you provided states a difference of more than 50kph between open and closed rads.
__________________
Reply With Quote
  #46  
Old 10-31-2011, 05:56 PM
41Sqn_Stormcrow
Guest
 
Posts: n/a
Default

Mh. Have you guys ever managed to slightly close the radiator of the 109 at full throttle without getting immediate overheat? I really don't see how one can close the rads almost full at full throttle without overheating it in split seconds.

In any aircraft when you are at full performance settings (throttle + rpm) I never ever dare to close the rads a little bit because overheating is looming.
Reply With Quote
  #47  
Old 10-31-2011, 06:08 PM
TomcatViP TomcatViP is offline
Approved Member
 
Join Date: Aug 2010
Posts: 1,323
Default

Quote:
Originally Posted by 41Sqn_Stormcrow View Post
Mh. Have you guys ever managed to slightly close the radiator of the 109 at full throttle without getting immediate overheat? I really don't see how one can close the rads almost full at full throttle without overheating it in split seconds.

In any aircraft when you are at full performance settings (throttle + rpm) I never ever dare to close the rads a little bit because overheating is looming.
For sure Max setting means the minimum time to enjoy - Tht's all abt men (quoting my ex-gf)

AoA you are talking abt some curves (a chart ) where are they ?!!
Reply With Quote
  #48  
Old 10-31-2011, 06:10 PM
335th_GRAthos 335th_GRAthos is offline
Approved Member
 
Join Date: Oct 2007
Posts: 1,240
Default

Quote:
Originally Posted by David198502 View Post
i surprisingly just found out that the rads settings of the 109 have no impact on speed at all...
normally i fly with them as much closed as possible,to avoid engine overheating,while maintaining the minimum air resistance...
however i found out that one can leave the rads fully open and still reach and hold the top speed in level flight....
Oh my God!

And despite no drag from the radiators, the Huricanes are faster than us???

~S~
Reply With Quote
  #49  
Old 10-31-2011, 06:15 PM
ACE-OF-ACES's Avatar
ACE-OF-ACES ACE-OF-ACES is offline
Approved Member
 
Join Date: May 2010
Location: NM
Posts: 2,248
Default

Quote:
Originally Posted by David198502 View Post
the whole document is twisted 90° left.
so the speed is actually on the y axis.
Disagree.. Look at the top of the document.. The heading is not rotated, which is the way it is scanned in and how it will appear when you click on the link. Thus all my references are to how it is presented. PS the word is rotated not twisted

Quote:
Originally Posted by David198502 View Post
but there is also the temperature on the y axis as well in the lower half...
Which pertains to the temperate graph.. which is not what we are talking about, we are talking about how it affected the speed

Quote:
Originally Posted by David198502 View Post
and the rads settings are on the x axis in mm.
If you want to rotate the graph, go for it, but all my references are to the graph in how it is presented (un rotated) in a typical 8 1/2 by 11 sheet of paper

Quote:
Originally Posted by David198502 View Post
so the doc you provided states a difference of more than 50kph between open and closed rads.
Nope..

Not based on the numbers I read, i.e.

(left) 520 - 530 - 540 - 550 - 560 (right)
__________________
Theres a reason for instrumenting a plane for test..
That being a pilots's 'perception' of what is going on can be very different from what is 'actually' going on.

Last edited by ACE-OF-ACES; 10-31-2011 at 06:18 PM.
Reply With Quote
  #50  
Old 10-31-2011, 06:19 PM
David198502's Avatar
David198502 David198502 is offline
Approved Member
 
Join Date: Dec 2009
Location: Austria
Posts: 1,536
Default

as cheesehawk says!

ace is suggest you to buy glasses
__________________
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 02:11 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 2007 Fulqrum Publishing. All rights reserved.