|
#1
|
|||
|
|||
Water problems
Hello to everybody
Recently I reinstall the whole SO and the IL-2 games, full updated drivers on PC and Video Card (Asus H6950). But when I edit the conf.ini file and try to change the Water=1 to Water=4 and start the game, the water=1 comesback again and it doesn't take the Water=4. What I am doing wrong? Do I have to edit another line in the conf.ini file? Thank you very much for your help. |
#2
|
|||
|
|||
You have to be able to run "perfect" terrain settings first. Make sure you've selected OpenGL render mode too.
|
#3
|
|||
|
|||
Quote:
|
#4
|
|||
|
|||
Quote:
Number ratings available: 0 is the simplest rendering 1 is simple hardware-rendered water-surface 2 optimized for AMD/ATI-cards 3 & 4 optimized for nVidia graphics cards Do your choice an then let the file read only Hope this helps. Cheers Giorgio |
#5
|
|||
|
|||
|
#6
|
|||
|
|||
Thank you
Thank you very much for your help and time to solve my problem.
|
#7
|
|||
|
|||
From the readme:
Water rendering To select water rendering mode please modify the Water section in the file conf.ini in the [Render_OpenGL] section (Water = 1 by default). Water = 0 – Water with flat geometry (fastest). Water = 1 – Water with flat geometry (fast). High quality water rendering modes with correct wave geometry Water = 2 – This mode is visually similar to water = 3 but it runs on ATI cards 9800, X800, X1800 and later models. Water = 3 – Fast render mode with Vertex Shaders 3.0 (NVIDIA 6600 and later models) Water = 4 – Better quality mode with Vertex Shaders 3.0 (NVIDIA 6800 and later models) Reminder: ATI 9500 and higher supports modes: 0, 1, 2. NVIDIA 6600 and later models support: 0, 1, 2, 3, 4. NVIDIA cards before the 6xxx series support: 0, 1, 2 (2 is not recommended). |
|
|