Overheating at the begining of a mission!

[Rince]

Hi mates!

sry, but i read already that there is a bug in the begining of a mission. The motor stops running (at the very begining) the temps are on the top and directly damage the coolingsys. I tried to find it in the forums, but didn`t manage to find it and its solution, hopefully)Is there something we can avoid this?
Thx and greets from the heart of nowhere!
Rince

[ATAG_Doc]

Hello

I assume you are using CEM.

Make sure you have your water and oil radiators open.

Don't over rev your engine(s).

Doc

[CWMV]

I believe he is referring to the engine overheat on spawn bug.
Yes, it Sucks.

[ATAG_Snapper]

Originally Posted by ATAG_Doc

Hello

I assume you are using CEM.

Make sure you have your water and oil radiators open.

Don't over rev your engine(s).

Doc

What Doc said.

For the RAF fighters - if you open your fuel cock immediately upon spawning in you'll prevent the engine from stopping. Next quickly open your water (glycol) radiator to 100% and you can start taxiing immediately -- you're good to go with no further warm up required.

[5./JG27.Farber]

Which aircraft Grabovski?

[Rince]

it was the 109....yes, i`m ok with all the cem stuff but i mean the spawn bug i never recognised like this before. I open directly the radiator but its`s overheating.....perhaps somebody got a hint...or i`ll try later..btw, it was in the desastersoft campaign and didn`t tried it on the others! I check it out and if i find something i let ya know!
Thanks for the soon replies. Do we have the same bug online? (i think-no, never realised...)

Rince!

p.s. see you soon online again...diablo is down...(again)

[SQB]

I have, on occasion, run into the same bug. On pressing I engine temps go off the charts within 2 seconds and the plane begins to sustain damage. The engine also does not start properly, spooling up, sputtering and then stopping.