Getting the TAS, TAA gauges in cockpit?

Voyager · #1 10-22-2009, 06:02 AM

What I'm wondering is if there is a way to get the true values flight gauge overlay from the ctr-F1 view, to display while in an in-cockpit view.

I just had a very nice quick mission (4x P-47D v 4x Bf-109K-4), and I wanted to review it with an idea of what was really going on, rather than just what the instruments were showing. I discovered the P-47's altimeter stops at 30,000ft, and I'm trying to figure out why the 109's sort of went non-evasive, which was really weird. That and #3 decided to do a loop with half a tail and no engine about 100ft off the ground, but that may have been injuries.

Harry Voyager

lep1981 · #2 10-23-2009, 06:46 AM

Voyager... I think that regardless of the limit mark in the airplane instrument you should be able to see the real altitude in the speedbar (lower-left corner) so, if you fly without it I think you might be able to see the data it shows during a replay if you activate afterwards and just for the replay... in the other hand, if you fly using the speedbar you should have any problems reading the real altitude and indicated airspeed.

If anyone have tried this with different results let me know

over and out...

HFC_Dolphin · #3 10-23-2009, 07:27 AM

Quote:

Originally Posted by Voyager

What I'm wondering is if there is a way to get the true values flight gauge overlay from the ctr-F1 view, to display while in an in-cockpit view.
...

Maybe you should wait for BoB

Voyager · #4 10-24-2009, 03:14 AM

Quote:

Originally Posted by HFC_Dolphin

Maybe you should wait for BoB

But... but there are no Thunderbolts in BoB, are there?