View Single Post
  #6  
Old 12-14-2015, 04:23 PM
Windturbin's Avatar
Windturbin Windturbin is offline
Approved Member
 
Join Date: Feb 2008
Posts: 56
Default FI software entries

Excellent reply Storebror, was hoping some one would throw the dog a bone!
I needed something to naw on! Now just need to figure out how to apply your information.

I sent an e-mail to FI tech support, but unfortunately their tech support is not as good as their product! Hopefully they will reply.

I have 9 gauges working, but the turn/slip one is a bit different. Here is what their software looks like for turn/slip......

[IMG][/IMG]

FI- had min value -1000 & max 1000 , I changed to -1 & 1 , but no joy.

[IMG][/IMG]

[IMG][/IMG]

This is were the problem may be with understanding how to set values to needle movements!!!! Can use anywhere from 3 to 20 needle values.

[IMG][/IMG]

Needle has position numbers , values per position?

Last edited by Windturbin; 12-14-2015 at 06:16 PM. Reason: Links
Reply With Quote