[Windturbin]

To Bolox or anyone who could help me.

I am looking into using the virtual gauges on a second monitor like you once suggested.

Maybe you could help me with some info?

So far, this is what I have done.........

* Added second monitor by using my second video card in my computer.(Works fine)

* Downloaded UDPSpeed along with some gauges and placed it in a folder on my hard drive.

* Dropped the gauges on to my second monitor screen. (Works fine)

* In my UDPSpeed config file I have this.....

[UDP]
IP=127.0.0.1
Port=21100

* In my IL2 config file I have this......

[DeviceLink]
IPS=127.0.0.1
host=127.0.0.1
port=21100

I have two problems, the gauges do not stay on my second computer screen, I have to re-drop them each time I re-start my computer? And most importantly the gauges do not work.

Am I missing something? Is there an additional software that I need? Am I suppose to also have something called devicelink? Is devicelink a software or is it a term?

Also if I check my computers ipconfig I come up with these ........

default gateway=192.168.0.1
ipv4 address=192.168.0.163
subnet mask=255.255.255.0

??????

Any help would be much appreciated!