Quote:
Originally Posted by Bolelas
So, almost a month and not a single coment? Is the thing so much crapp? At least a coment with the faults and defects!!
|
Nice work.. This is my first time in this thread..
Quote:
Originally Posted by von Pilsner
That thing is amazing!!! It's very impressive. The best I could do was to wire a gamepad into a radio shack box.... 
Well one day I may wire up some pots for trim controls to it. |
You can always mod your X-52. The X-52 is easy to modify if you have something lke a Dremel tool that you can use to cut through the plastic. It is modular. It is much easier to mod than the X-45 was. Since I use a MSFFB2 as my main flying stick I started out using my X-45 as a button bay. When it died I decided to to the same thing to the X-52.. I left the throttle just as it was.. I just modded the stick.
For those who are interested.
My modded X-52
Components of the stick removed from the handle and shaft. I replaced the hall effect sensors on the X & Y axii with pots. The are the two red knobs. The blue knob s the Z opt removed from it's spring loaded casing. See picture below for wiring. The Z pot I left as it was. I now use it for Rudder trim. I don't use them for anything yet.. but if mixture or something else
Close ups of Hall Effect sensors on X-52