Today I tried to finish the front plate.
I took my little helper (which you can see below of my trimwheel) and made 2 little cuts for each trimwheel. After that I used a saw to deepen it.
Then again with the dremel( ok, it not a real dremel ) cuting the strips out.
After 4 hours of work, it still needs some adjustments so that I can turn the wheels without touching the housing with the rings.
Also it was a good idea from me to screw the rudder-plate on the back-housing.
Because to fit everything together I had to screw it of first.
Putting all parts together ( wiring, switches, trimwheels, housing) will become the toughest thing...
I also attached the side parts for checking, but they aren't drilled now for final assembly. The hole for the USB-cable is also missing.
Enough of words! Pics, pics, pics!!!
PICT0031.JPG
PICT0036.JPG
PICT0035.JPG