Thread: Artifacts
View Single Post
  #5  
Old 01-06-2012, 01:07 PM
TekUK TekUK is offline
Registered Member
 
Join Date: Jun 2009
Posts: 2
Default

Temps are not an issue, According to CCC, But lowering the GPU clocks on the core helped, the only artifact I had was on the rotor blades, They seem to have small squares inside of them as if they were poking out you know.

Lowered the factory clocks from 915 & 1050 to 900 & 1000. seemed to help alot.

But then I crashed into the back of a HE 111 lol
Dont ask. I Dived at him and he pulled up as I was like 100ft away from him about to pull up myself. Double trouble ay hehe.

But yeah, I've cleaned off the dust. I've lowered the clocks, and it seemed to help alot, the game is playable. Now that I can see what I'm doing

Thx guys, I appreciate this alot. I do know that my 6870 does not work on youtube and other flash video players with Hardware Acceleration turned on. I get blocky artifacts all over the screen.
Turning H.A. off fixed this, but never had it happen in a game.
Those blocks do happen when Cod Is on the loading screens also. So maybe the loading screens use some kind of H.A.

Think I might get HWMonitor to run during a game just to see if my temps stay at a normal rate. or if they jump from high to ultra high
They seemed fine during game, but it would not hurt to try more software, just incase the other gives a false reading.

Anyway, Thx guys, I appreciate the help.

Silly Factory OC.


Image of current temps after 1 hours gameplay.

http://imageshack.us/photo/my-images...061521530.jpg/

Might have to zoom in with this image, its a bit small. Imageshack didn't keep its original ratio.

Last edited by TekUK; 01-06-2012 at 02:26 PM. Reason: added temps image.
Reply With Quote