Quote:
Originally Posted by Redroach
real manuals do help, in general, but in this case the blen's FM is quite a bit off in terms of engine temps. Leave the coolers open until safely in the air and your engine temps start to drop.
And, in my experience, there is no such thing as "the oil gets too cold". Shortly after T/O, I set prop pitch to coarse, engage carb heaters at 5500 ft - with these actions, my oil temps were fine all the time.
|
Ok. I thought I saw some connection between engine failure and low oil temp but if I understand you correct then the crucial thing is the engine temp which I should try to keep between 200 and 250?
Could you confirm this...
- Open rads lowers engine temps (and vice versa)?
- Activated carb heaters raise engine temps (and vice versa)?
- Throttling up i.e. higher rpm raise engine temps (and vice versa)?
How does coarse pitch affect the temps? I mean, lower rpm gives lower temp but coarse pitch give higher load on engine.
Quote:
Originally Posted by Redroach
My "engage AP for a second" referred to the wheel brakes, btw. Are you sure that the tailwheel gets locked, too?
|
I ment wheel brakes. Sorry.
Thanks!