Hi folks,
For those having problem with removing read only for folders here's a step-by step instructions.
1. click on windows "start" menu
2. click on "Run"
3. in the box where it says "open" type "cmd" (without the quotes)
4. when the dos box appears type the following:
cd c:\Program Files\Ubisoft\IL-2 Sturmovik 1946\PaintSchemes
in the above example you should substitute the correct path to your games folder if it is not installed on C drive in the default folder path as per the above example. Make sure to add the PaintSchemes bit to the end.
and hit the "enter/return" key on your keyboard
5. When the path displayed changes to the above type the following without the quotes "attrib -r Regiments"
and hit the enter/return key
6. then type
"attrib -r Cache" again without the quotes and hit the enter/return key
That's it. I downloaded the new installer and ran in here on a works PC and then ran MAT Manager, made a few markings changes and then exited and I never had the Read Only problem so it would appear that there's nothing wrong with the files zipped in the installer being zipped as read only.
Please try the above.
Also please remember to add the ClearCache=0 command to the [game] section of your conf.ini else you will not see any MAT Manager markings.
The Netcache folder isn't used by MAT Manager only the Regiments and Cache folders it is these folders that must not be read only.
Regards
Aces
I'm afraid that vehicle markings cannot be changed as the skins with them on are hard-coded into the game.
|