Is this for all ac?
My X52 is fine so it may be worth checking the CoD control menu Z axis sliders for throttle. The 100% value slider should be far right (small dot in slider), the others are all far left. You should see the 'input' and 'output' graphs (on right of screen) matched. If you are finding that inputting 1/3rd still results in full output then check the control panel for the X52 and make sure that the throttle slider is set for full travel (in the deadzones tab set up menu).
Other than that I cannot think of anything else.
Last edited by SEE; 05-14-2011 at 01:23 AM.
|