As far as I'm aware, the only specific details given about this were in the initial TD announcement of the feature:
Quote:
At present all aircraft in IL2 have a single fixed Structural G limit of +13G. It only really becomes an issue with aircraft with exceptionally light elevators such as the P51. Pull more than +13G and you loose your wings. The real life situation is a little more complicated. Real aircraft are designed with an Ultimate load and In Service design load. Both are for a defined configuration and weight.
The in Service load is the typical G available to the pilot. As long as this the G is not exceeded then no aircraft damage will occur. Exceed the In service G limit then damage of varying degrees may occur .. like bent airframes etc. Exceed the Ultimate load then severe damage will occur typically resulting in structural failure ... like wings coming off etc.Typically a safety factor of 1.5 is used. So an Fighter aeroplane with a design In service G limit of say +8G will have an Ultimate load of +12G. As external stores and or weight is increased above the design weight both G limits reduce accordingly. Reduce weight (by dropping bombs or burning fuel etc) and your G limits increase. Bomber and Transport aircraft have G limits much lower than fighters.
So if you abuse the limits you damage the aircraft. Once damaged then its structural integrity is reduced so the ultimate load reduces as well. In other words keep bending the airframe and you will eventually weaken it to the point that very little extra G is required to induce structural failure. A bent airframe wont perform as well either.
The DT team have now simulated this for the first time in IL2. Each aircraft has been given a unique Structural G profile for Ultimate load, In service limit, and dynamic Weight based limits . In addition this is dynamically modified with its own G induced damage profile. The basic Design Ultimate load configuration and weight has been defined as Default load + 100% Fuel. The actual Ultimate design load has been based on Historical values where they are known and guesstimation where they are not known. In broad brush terms for fighters have an Ultimate design load of +12G with an In service limit of +8G. Lets abbreviate this to 8G/12G
How does this work in game ? You take your stock standard Fighter MK 1 with Default armament +100% Fuel your limits are +8G/+12G. You add 2 x 500lbs bombs. your limits now reduce to 5G/8G. So prior to the target you need to be a little more careful with your aeroplane. Lets say pre target you pull + 6G, you have exceeded the In service limit, you will hear a damage sound cue and suffer a slight aerodynamic penalty. In addition your G limits have now reduced to say 4G/6G. (Bust these again and further aerodynamic penalties and further reductions will apply). You progress to the target and release your bombs. Since the weight is reduced your limits will increase but since you already bent the airframe you wont get back your original limits. You might then get say +6G/+9G. As you can see if you keep abusing the limits you will end with a very weakened airframe.
In the case of heavy bombers G limits will prevent any real aerobatic manoeuvers. You will still be able to evade quite well but you wont be able to BFM with aeroplanes like the A20 anymore. Bombers will be just that: Bombers. G limits will be applicable to AI planes as well and they will fly in a more realistic way too.
Is G displayed? Unless the aircraft in game is equipped with a G meter then no. So you will need to re think how you fly. Random snatches particularly at high speeds are going to hurt .... just as they do in real life. You will need to be aware of Corner speeds because any time you are faster than Corner speed you run the risk of an Over G event. (We are yet to finalise the display side of things)
|
http://forum.1cpublishing.eu/showthr...ile#post136666
I suspect any further info about this will have to wait until the patch is released - hopefully not too long now.