Water problems
 

Hello to everybody:)

Recently I reinstall the whole SO and the IL-2 games, full updated drivers on PC and Video Card (Asus H6950). But when I edit the conf.ini file and try to change the Water=1 to Water=4 and start the game, the water=1 comesback again and it doesn't take the Water=4. :confused:

What I am doing wrong? Do I have to edit another line in the conf.ini file? :(

Thank you very much for your help.

You have to be able to run "perfect" terrain settings first. Make sure you've selected OpenGL render mode too.

I believe water= 2 is the setting your going to want for that card.

Water:

Number ratings available:
0 is the simplest rendering
1 is simple hardware-rendered water-surface
2 optimized for AMD/ATI-cards
3 & 4 optimized for nVidia graphics cards

Do your choice an then let the file read only
Hope this helps.
Cheers
Giorgio

http://forum.1cpublishing.eu/showthr...t=28387&page=2

This might be helpful :)

Thank you
 

Thank you very much for your help and time to solve my problem. :)

From the readme:

Water rendering

To select water rendering mode please modify the Water section in the file conf.ini in the [Render_OpenGL] section (Water = 1 by default).

Water = 0 – Water with flat geometry (fastest).
Water = 1 – Water with flat geometry (fast).


High quality water rendering modes with correct wave geometry
Water = 2 – This mode is visually similar to water = 3 but it runs on ATI cards 9800, X800, X1800 and later models.
Water = 3 – Fast render mode with Vertex Shaders 3.0 (NVIDIA 6600 and later models)
Water = 4 – Better quality mode with Vertex Shaders 3.0 (NVIDIA 6800 and later models)

Reminder:
ATI 9500 and higher supports modes: 0, 1, 2.
NVIDIA 6600 and later models support: 0, 1, 2, 3, 4.
NVIDIA cards before the 6xxx series support: 0, 1, 2 (2 is not recommended).