Cannot get static a/c to show marking in FMB
 

I have asked this a couple of times in previous posts but have yet to get an answer. I am sure earlier on I had static a/c showing markings in the first mission I built in FMB. I think there was a show markings tick box at one stage for static a/c. Can anyone verify this or am I losing the plot?
I have spent a considerable amount of time trying to figure this out to no avail.
It's probably going to be something ridiculously simple, but can someone tell me how please, or at least confirm it is not possible at this stage?

I have the same question - but the inverse. I want to turn off markings, but after googling my brains out haven't found the answer (or a tick box). Anyone?

Gz people

The author asked about how to place markings on stationary aircraft and within a twelve minute spread, one says he can, and one says you can't!

Which respondant didn't read the post correctly, OR WTF?

I think that this is why you have to ask three times before getting an answer here.

For the record, I have read that you cannot, but can't tell you first hand.

Gz JG26_EZ, why do you think I put my text in BOLD? because I know you can't have markings on static planes because I create missions on almost a daily basis. I have created missions in old IL-2 for ages too and in that FMB you can have markings on static planes in CloD you can't, go figure. Finito, loppu, slut, the end!

Right, already reported to the devs here
http://www.il2bugtracker.com/issues/67

@ addman

Bold doesn't mean "jack". I know where the BOLD button is too. My post was directed at those that post incorrect info.

If you are correct you didn't have to respond to my post. Instead, you might mention why Tailspin's answer is incorrect.

I'm not trolling, I'm just asking for people to "get it right"

Well I am right in this case that's why I felt the need to be "BOLDER" then the other poster. I didn't say you where trolling, nor do I think you are so let's leave it there shall we.:)