COd just went from 10fps to 40.
 

Hi!

i just fixed my Cod issues, wich i was having since last official release.

my FPS just had a boost, london is now flyable on about 20 fps alone. and stutters are preaty much gone. I used to have stuters all the time and some 20 fps tops, in london i got 1/3 of fps.

the reason?

apparently on the last install from scratch :rolleyes:steam:rolleyes: wrote on my conf.ini:

[window]
DepthBits =24
StencilBits=8

And when replaced by

[window]
DepthBits =32
StencilBits=16

changed the whole game for me. Im up for flying jsut wanted to leave the tip to people having desaustrous performances.

cheers

I just tried that in a few SP missions. It seems a lot better so thanks for sharing. Will try a few more.

That gave me an extra 10-15 fps, thanks!

Not sure if it's just a placebo effect, but the game feels smoother now. Especially over London where stutters are now virtually non existent!

jsut tried online, had always 25+ ecxcept when i attacked a group of bombers, and got stuck at the 15-20 range, and some stutters.

its starting to feel playable.:grin:

Amazing! You discover a MAJOR bug in last Beta/Official patch! More FPS here and I don't have the gigantic "sun glare"!

PLEASE MG NOTE THIS!!!!

Thanks
 

Nice one!

Aloha!

I just tried it, but for me it doesn`t make an obvious difference! I still got the problem that i got stutters at a special altitude and when I`m looking to the front! When I`m turnig my head sideways, it runs fluid an with a good fps! I once read in the forum that it`s about the upcoming textures that needed to be load, but that doesn`t explain why it`s ok, when I`m fying at a low altitude looking to the front without stuttering!
But anyway, i wait for the release of the patch maybe it runs better.

Thanks for the tip!

Rince!

Where do I access these config files? thanks

Go to your 'My Documents Folder' where there should be a folder called 1c Softclub of something. Then click on that and open the IL2 CLiffs of Dover folder and in there you'll find a load of files and folders. Click on the Conf.ini and there you go!