Thanks for the suggestion - I'll have a go at that. The other X52 mod to increase spring tension is just terrible.

My spring is pretty relaxed after the three years I've had the X52 Pro. I do prefer the lighter feel, it was very heavy to start with.

However I have completed stage 1 and done the video'd magnets mod and I realise now that the standard setup has a mechanical deadzone because the Hall sensor doesn't react to the first millimetre or two of stick movement at the centre. If you couldn't see on the video (it was a bit dark in the stick base), the sensor sits between two opposite polarity magnets which swing towards/away from it depending on which way you move the stick' It changes its output as one of the magnets moves closer to it. The initial travel had no effect on the sensor until one of the magnets got a little closer.

I really like the immediate (modded) response to movement at the centre which I hadn't noticed I didn't get before. Makes for more precise flying (as opposed to dead-zone flying) although it needs close attention when you're aiming etc..

I doubt if I'll do the spring tensioning mod though.

Now to order some magnets and sensors for the Throttle pots mods. I think there'll be enough room on top of the rotary spindles for some bluetack and magnets plus the sensor. I think I'll need diametric magnets as they will revolve under the sensor instead of moving across it. Hmmm.... or I could make a little arm for them to swing on if there's room.

Has anyone tried that yet?

Well I stripped the Throttle and there is simply not enough room to get magnets and sensor in to replace the Rotary pots. One pot was a faint possibility but the myriad of wires running over the existing pots makes it a very risky business so I will leave it.

Almost done... everything works.. I just have to come up with some kind of cover and some kind of knob for the two Z & Y sliders in the middle. The red switc is the shift button and the two black buttons are triggers 1 & 2. Knob is Z pot. The st6ick is hed to the throttle with velcro so I can take it apart if I have to ever fix anything... I had to expand the base of the stick beyond what I had initially cut.. All the boards are on the top part and all I have to do is disconnect the sliders from the board underneath.


http://file.walagata.com/w/bearcat/X-52_1.JPG


http://file.walagata.com/w/bearcat/X-52__2.JPG