Official Fulqrum Publishing forum

Page 2 of 2

Show 100 post(s) from this thread on one page

Official Fulqrum Publishing forum (http://forum.fulqrumpublishing.com/index.php)

- Controls threads (http://forum.fulqrumpublishing.com/forumdisplay.php?f=194)

- - Trims ? (http://forum.fulqrumpublishing.com/showthread.php?t=20152)

lbuchele

04-02-2011 03:38 AM

Regained trim control after disabling Antropomorphic.

TheGrunch

04-02-2011 07:20 AM

Quote:

Originally Posted by Wolf_Rider (Post 249047)

The new method takes a bit of getting used to but is much better than the previous method. I quite like it

It's still nowhere near as good as IL2-Joycontrol or the new joystick settings screen that DT added in the 4.10 patch to 1946 though, which is a shame. :(

JZG_Con

04-04-2011 11:19 PM

Quote:

Originally Posted by III/JG11_Simmox (Post 248231)

109 trim only elevator
only seems to work in campaign,havent tried single mission
certainly not working in quick mission

ive spent sometime with it now
try adjusting the deadzones in game on the sliders you are using

had awful trouble with trims and throttle until i played with the deadzones
even the prop pitch needed attention
reasonably happy with the settings now

tried in single mission not working , .i was trimming like mad ,,lol...

15JG52_Brauer

04-04-2011 11:22 PM

Quote:

Originally Posted by JZG_Con (Post 252274)

tried in single mission not working , .i was trimming like mad ,,lol...

Con - it works (elevator) - pm me or message me on JZG forum

IvanK

04-05-2011 12:09 AM

Running CH stuff Trim working just fine in all game modes.

Blackdog_kt

04-05-2011 04:11 AM

There's a bug in the 109: a lot of controls don't work if you use simple engine management, maybe trims are among them. Developers know this and it's on the "to fix" list for the patch.

Apart from that, i like how the game forces people to use the controls the same way a real pilot would, at least on high realism settings.

All times are GMT. The time now is 09:12 PM.

Page 2 of 2

Show 100 post(s) from this thread on one page